DNS-320 – cpuinfo and meminfo

For those who are curious about the DNS-320’s cpu and memory. The DNS-320 comes with a 800Mhz CPU and 128MB of RAM.

/ # cat /proc/cpuinfo
Processor       : ARM926EJ-S rev 1 (v5l)
BogoMIPS        : 796.26
Features        : swp half thumb fastmult edsp
CPU implementer : 0x56
CPU architecture: 5TE
CPU variant     : 0x2
CPU part        : 0x131
CPU revision    : 1
Cache type      : write-back
Cache clean     : cp15 c7 ops
Cache lockdown  : format C
Cache format    : Harvard
I size          : 16384
I assoc         : 4
I line length   : 32
I sets          : 128
D size          : 16384
D assoc         : 4
D line length   : 32
D sets          : 128

/ # cat /proc/meminfo
MemTotal:       125632 kB
MemFree:          1864 kB
Buffers:         11672 kB
Cached:          86828 kB
SwapCached:          0 kB
Active:          49196 kB
Inactive:        58236 kB
SwapTotal:      530040 kB
SwapFree:       530040 kB
Dirty:           10348 kB
Writeback:           0 kB
AnonPages:        8948 kB
Mapped:           7712 kB
Slab:            13084 kB
SReclaimable:     2224 kB
SUnreclaim:      10860 kB
PageTables:        448 kB
NFS_Unstable:        0 kB
Bounce:              0 kB
CommitLimit:    592856 kB
Committed_AS:    35784 kB
VmallocTotal:   516096 kB
VmallocUsed:      1236 kB
VmallocChunk:   514856 kB

6 thoughts on “DNS-320 – cpuinfo and meminfo

  • November 29, 2010 at 10:08 am
    Permalink

    If this is truly a Marvell Sheeva CPU clocked at 800Mhz, then this belongs to the same family of plug computers: http://www.plugapps.com/index.php5?title=Portal:Hardware. Synology and Qnap are also starting to use the chip in their consumer NAS products.

    Probably this boots from uboot too.

  • December 24, 2010 at 7:48 am
    Permalink

    Hi Andy,

    how do you telnet into the nas to get the cpuinfo and meminfo?

  • December 24, 2010 at 10:58 am
    Permalink

    hi newbie,

    fun_plug it

  • January 14, 2011 at 5:36 am
    Permalink

    Hi Andy,

    If I get two of these – one for me and one for a family member – can we get them to sync over the internet? Either with the default setup or with fun_plug?

    Thanks,
    Jim

  • January 14, 2011 at 5:17 pm
    Permalink

    Hi Jim,

    I think it is possible. You can try doing a rsync over ssh (through Internet). You can set this up using fun_plug. 🙂

  • January 14, 2011 at 9:55 pm
    Permalink

    Thanks Andy,

    From what I’ve read a lot of the NASs that come with this function built in use rsync under the hood, so if it’s possible to get rsync running over the internet using fun_plug I should be in with a shot!

Comments are closed.