Synology DiskStation DS916+ Review

Setting up Disk Station Manager

The set up is a straightforward process. Once the Synology DS916+ is (physically) connected to your network and powered up, launch a web browser and navigate to http://find.synology.com. The discovery and setup process will guide you through the installation of Disk Station Manager (DSM).

Using http://find.synology.com to locate Synology products on your network

It found several Synology products, one of it is the Synology DS916+

Selected the Synology DS916+ for setup

Installing the DSM is the first step for all Synology NAS appliance

Downloading and installing the DSM takes less than 10 minutes for me

Downloading and installing the DSM takes less than 10 minutes for me

Rebooting the DS916+ to complete the installation of DSM

Creating the administrator account for DS916+. Must remember NOT to lose the password to this account

Ok. The administrator account has been created

Selecting the patching regime

Setting up Synology Quick Connect to facilitate remote access
Setting up Synology Quick Connect to facilitate remote access

Confirmation of Quick Connect address

Completed the initial setup. Time to launch DSM

The welcome guide to DSM

The welcome guide to DSM

The welcome guide to DSM

The welcome guide to DSM

 

Treat shadowandy!

If these step-by-step guides have been very helpful to you and saved you a lot of time, please consider treating shadowandy to a cup of Starbucks.  

Close